Hot Tips To Fix Tough Plumbing Problems

Did you know that a leaky spray head on your kitchen sink might be caused by a faulty diverter? If this peaks your interest or if you want to know more about plumbing, then you will want to read what else we have to provide in this article about how to take care of plumbing in your home.

Solder with safety in mind. When you solder a copper pipe you want to direct the flame on the copper pipe. The flame of the torch has to be four inches away from the piping. The flame should be targeted directly at the point where the copper piping needs to be disconnected.

When starting a plumbing project that is due to loud noises in your pipes empty the pipes first. This can be an easy fix to an other wise wasted huge job. Just close the main water line and open the facets throughout the house. After the water has stopped flowing turn the water on from the main source and check to see if the noise is eliminated.

If your water pipe has frozen, start water running in the faucet closest to the frozen pipe. This will give excess water somewhere to drain as the ice in the pipe thaws. This will relieve pressure and might prevent the pipe from bursting, preventing further damage.

Unclog drains with ease. Try using a plunger and drain cleaner, as your clog may simply be a build-up of hair and debris. If this doesn’t work you may have to clear the drain with a snake. Feed the snake into the drain line as far as it will go. Turn the crank gently, which will help to loosen the clog. Remove the snake, and run water down the drain to see if the clog has been removed. You may have to use the snake a couple of times, before the clog is cleared so don’t give up!

Make sure you clean out overflow holes in your kitchen and bathroom sinks on a regular basis. These holes are intended to act as an emergency fail-safe to prevent spillage from a full sink, but if they are clogged they can’t do their job. You can clean out an overflow hole using the same techniques you would for a clogged drain.

Avoid using hard cleaners on your toilets, such as drop-in cleaner tabs in the tank. When these tabs are almost completely dissolved, what’s left of the tab gets washed into the bowl. This can then end up clogging the toilet’s port holes, preventing the toilet from flushing properly. It can take months for this debris to finish dissolving in those holes.

There are many ways to unclog a drain. You can try plunging it at first. If that doesn’t work try using a chemical agent from the store. Before you go and spend money at the store though, if you have baking soda and some vinegar handy, you can mix those together and pour them in the drain and try to plunge that but if all else fails they have stronger remedies at your local hardware store.

In conclusion, that leaky faucet may just be easier to fix than you imagined. Instead of making a call to a plumber, having to wait, and then paying out top dollar, you can now fix it yourself. Use this advice to put yourself in the best financial situation possible when it comes to plumbing.