Solid Plumbing Advice For The Do-It-Yourself Homeowner

As fun as planning to do your own plumbing can seem, it is a very important reason to start learning how now. Another thing is that it can save you a lot of money in the future, so you can handle any issues yourself. These tips below can help you start.

Solder with safety in mind. When you solder a copper pipe you want to direct the flame on the copper pipe. The flame of the torch has to be four inches away from the piping. The flame should be targeted directly at the point where the copper piping needs to be disconnected.

Ensure that everyone in your household knows how to turn off the main water supply, or knows how to contact someone who can. In the event of a burst pipe or other water-related emergency, you should immediately turn off the water to prevent flooding, structural damage, and a sky-high water bill.

To keep your septic tank in good working order, it is advisable to have it pumped out every five years. Having your septic pumped will keep sediments from settling to the bottom of the septic tank and causing the tank to malfunction or backup. It is a small price to pay now to keep your septic in good working order and prevent having to pay for a major repair caused by a backup.

Don’t throw trash down your toilet. Doing so can clog the drain and cause plumbing problems. Don’t flush cotton balls, diapers, paper towels, or anything else that doesn’t dissolve, as these can clog it. In addition, you should only use the amount of toilet paper that is absolutely necessary when cleaning yourself.

Find out the plumbing codes in your local area before starting any project. Plumbing codes can vary wildly from area to area and you don’t want to run afoul of the codes. Visit your local building department to find out information or hire a plumber for a day to help you go over your plans and provide advice.

You can remove unsightly mineral buildup from your shower head by soaking it in vinegar overnight. This loosens the deposits, and in the morning you only need to wipe off the residue with a rag. If your shower head is high up an not removable, place vinegar in a plastic bag, slip the bag over the shower head and hold in place with a twist tie.

Correct low water pressure problems caused by sediment buildup by cleaning the aerator. First, you need to remove the aerator, and then take it apart and clean it using a small brush that has been dipped in vinegar. Finally, rinse off the aerator, put it back together and then reattach it to your faucet. Removing obstacles in aerators should improve the water pressure.

While planning to do your own plumbing was incredibly interesting. You should feel better you know how to do it correctly and safely. You can now apply your newly acquired plumbing skills and knowledge either to maintain your plumbing, trying to repair it, or bettering your own home system.